UNDERSIZE BRAKE PUMP MOUNTING FLANGE (-0.030in Undersize) (UE9490-0.030SXR)

Very often problems with brake pumps and low system pressure are caused by wear on the lobe on the camshaft that activates the brake pump push rod. In order to try to rectify this problem without having to replace the camshaft (a very costly job) we have machined these flanges to be 0.030" (inches) thinner than the original. If your camshaft lobe is worn then we recommend fitting this flange and then shimming the flange in order to obtain the correct push rod heights. Further information related to the fitting procedure can be found here.

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating     Bad           Good

Continue